Skip to Content

Red Lightning Bolt Symbol On My Jeep Dashboard | Fix Now!

Red Lightning Bolt Symbol On My Jeep Dashboard | Fix Now!

It can be alarming when something lights up on your dash, especially if it looks like a warning sign or symbol.

If you see the red warning bolt on your Jeep dashboard, it usually indicates that there is a problem or fault with the ETC (Electronic Throttle Control).

In this guide, I am going to discuss what steps you should take if you see this symbol and what you can do to fix the problem.

Let’s take a look.

What is The Red Lightning Bolt Warning?

A sensor kicks in when the throttle is opened, which measures the pressure. The clever technology sends a signal from the pedal to the engine throttle via a motor.

If the red lightning bolt is appearing on your dashboard, chances are, there’s a communication error.

However, don’t panic too much. If the warning light appears while driving, you do not need to pull over immediately. However, it’s best to get your car to a mechanic at the next available opportunity, where they can correctly identify the problem.

Resetting The Red Lightning Bolt Warning Sign

Resetting The Red Lightning Bolt Warning Sign

In some cases, the red lightning bolt might be because of a potential fault rather than a current one. For instance, if the pedal position has altered. If this is the case, there are steps you can take to perform a reset to get rid of the lightning bolt.

  1. Turn on the ignition (but do not start the car).
  2. Slowly put pressure on the gas pedal before returning it to the resting position.
  3. Start the vehicle.
  4. Try pressing the gas again to see if the lightning bolt goes off.

What Causes The ETC to Malfunction and How To Fix?

The ETC might have malfunctioned due to a fault with the electrical circuit. If this is the case, it’s a pretty easy fix as long as you know what you’re doing and if you have a multimeter.

However, if you’re unsure, it is best to be looked at by a trained mechanic to ensure you don’t cause further damage.

If you are handy in this area, you can follow the steps below to repair the issue.

  • Locate and examine the fuse box.
  • From here, you’ll need to use your multimeter to check for any loose connections.
  • When the meter reads zero, you’ve found your loose connection.
  • At this point, you’ll need to replace the Jeep’s dashboard and rewire all the connectors.

Frequently Asked Questions About The Red Lightning Bolt on a Jeep’s Dash

Seeing any warning sign on your dash can be a worry, so let’s take a look at what other concerned Jeep drivers have been asking!

What Should I Do If the Red Lightning Bolt Light Comes On While Driving?

You don’t need to stop immediately if the light illuminates while driving. But you should address the problem at the earliest possible point to prevent engine damage.

Can I Continue Driving with the Red Lightning Bolt Light On?

It’s generally not recommended to continue driving with the red lightning bolt light on, as it may indicate a severe issue that could lead to further damage if not addressed immediately.

How Can I Prevent the Red Lightning Bolt Light from Illuminating?

Undertaking regular maintenance, such as checking for any loose connections, cleaning the throttle body, and using good-quality fuel, can help prevent issues that may trigger the red lightning bolt light.


While the red lightning bolt on your dashboard, illuminated in bright red, might seem alarming at first glance, it doesn’t always mean a catastrophic problem.

The reason for the red light can be as simple as a loose connection, which can be easily fixed with the right equipment and knowledge.

If the problem is left unexamined, this could lead to more severe and costly damage to your Jeep’s engine.